*55-56-57 CHEVY* (above)*** *DRAG*CIRCLE TRACK*STREET ROD*PRO-STREET* If you're looking for something alittle more specific, we're fully equipped to bend frames to your specifications. This page will assist you, as well as us, in meeting all of your needs. Take a look and give us a call. We're more than happy to give quotes, technical assistance, or just plain advice!!
Example of one of our mandrel bent chassis. It is a perimeter type designed for a 37-40 Ford street rod with all the usual stuff up front but in the back is set up for a "Cobra Mustang Independent" in which the "suspension cradle" bolts right in to the chassis BELOW....This is an example of some of the complexity of some of our work. S10 SHOWN below... ***** This frame was recently shown on the hit TV show "OVERHAULIN". An "AUTO WELD" full roller chassis was used for the construction of the "NAPA" truck. This same truck is shown in detail in the MAY '06 issue of "SPORT TRUCK" magazine. Along with other builds in other magazines.
FRAMES*FRAMES*FRAMES* Our frame rails are made from 2x3x11ga. and 2x4x11ga. rectangular steel tubing. We can bend from our accumulated specs, or we can bend from your specs. QUANTITY DISCOUNTS available. Typical pricing is as follows:
***AUTO WELD has full length "bumper to bumper" (one piece) rails with an average price as little as ($899.95 for 2x3...per pair) and ($978.50 for 2x4 per pair) in "parallel" fashion.
***
Custom bent full 2x4 "perimeter type" frame rails with an average price of $1350-$1860 per pair.
***
Prices may vary depending on the length, how complicated and the number of bends of the rails that are to be bent.
***
Rear 2x3 frame rails: typical 4-link or ladderbar and OEM type, start for as little as $328.50 pr.
***
Custom bent 2x3 rear rails start at $540.00 pr.
***
Custom bent 2x4 rear rails start at $680.00 pr.
***
All frame rails sold in pairs! SHOW QUALITY BENDS...NO WRINKLES! Call for best price.
***
*CUSTOM PERIMETER FRAMES*
Made from mandrel bent 2x4 box steel
(above and below)
***
"FACTORY SHAPED"
**
REAR FRAME RAILS
Made from 2x3x11ga..
The good stuff!!
"PARALLEL TYPE"
**
"NO WRINKLES"
***
NOTE: mandrel bent rear "PROFILE" rails incorporate some welded areas to create the "profile effect" like factory.
'70-'81 Camaro "PARALLEL" rails are mandrel bent, but also have a welded area. This typically is done because of mating two curves together.
**
PLEASE NOTE :
Our "Factory Shaped" frame rails are used for narrowing you frame for more tire room. Although they can be used for a much stronger custom replacement rail...they are not OEM rust replacement rails that have to be spot welded into the vehicle. Some fabrication is needed to install.
------------------
***Please Note:
All 2x3 "Factory Shaped" frame rails are "parallel" except where noted as "profile".
New '61-'64 FALCON
"FRONT RAILS"
Factory Shaped
but,"Parallel".
2x3....... $328.50 pair
"PROFILE RAILS"
These rear rails are designed to replace the original "OEM" units. Great for replacing those rusted out units where you don't want to change the location of the springs. Rails are mandrel bent 2x3x11ga box steel and are made into the stock profile shape. Also included are the shackle sleeves already installed.
**
67-69 CAMARO PROFILE RAILS...$624.95 pair
**